qertcomic.blogg.se - Rose easy origami flower

Refer to the video at the top of the post to see exactly how we made these beautiful DIY paper flowers.

Adding simple paper leaves to your flower.

Modpodging glitter to certain petals of your flower for a little extra sparkle.

Fold it in half (this is called a book fold) along both the vertical and horizontal, to give four quadrants. Total time: 20 minutes Step 1 Start with a piece of 15 x 15cm origami paper.

Adding glitter to your paper before cutting it For the purpose of this step-by-step tutorial for this easy origami rose, we have used paper that is pink on one side and yellow on the other.

You can decorate your paper flower a little bit more by: This should stay in place on its own, but you can also add hot glue to keep it secure. Then use your scissors to carefully poke a hole in the bottom center of your flower, and slide the stem in. Seal the end of your stem in place with hot glue. If it seems a little short, you can try lengthening it by gently pulling the ends. Start in one corner, and carefully roll diagonally until you’ve rolled it up completely. To make the stem, trim your text weight paper to 2 x 10″. Hold it in place until the glue has dried so that it doesn’t unravel further.Īt this point, you can leave your flower as is, or move on to make a paper stem.

Now that your flower is tightly rolled up, place it on the table and let it go, so that it will unravel slightly to reveal a beautiful spiral flower.Ĭarefully apply hot glue to the bottom of your spiral flower and securely press it against the round end of your spiral that was left as your flower’s base. Try to keep the straight edge of your spiral lined up as you roll.

Take the outer end and start tightly rolling until you get to the round center. Once you’ve cut your spiral, go back and cut a wave pattern on just the outer edge (this can be uneven for more interest). When you get to the center, leave the end as a small circle in the middle, which will be a base for your flower. Start at any point of the circle’s outer edge, and cut it into a spiral shape (the cut should be about 1″ in width). (This does not have to be a perfect circle!) Next, use scissors to cut your square into a circle by trimming close to the sides and rounding off the corners. Experiment and make a variety of sizes! Step 2 Cut your cardstock into a square using your paper trimmer – the size of the square depends on the size of the flower you’d like. We cut our 8.5 x 11″ cardstock down to a 6 x 6″ square in this tutorial.